1,051 found, showing page 14 of 71
$5.79
2X4 JOIST HANGER Z-MAX
This hanger features patented double shear nailing, which distributes the load through 2 points on each joist nail for greater strength. It also allows for the use of fewer nails, faster installation, and the use of common nails for all connections. 18-gauge galvanized steel. Some double shear joist hangers are available in ZMAX coating.
View Details
$7.29
2X6 JOIST HANGER ZMX
This hanger features patented double shear nailing, which distributes the load through 2 points on each joist nail for greater strength. It also allows for the use of fewer nails, faster installation, and the use of common nails for all connections. 18-gauge galvanized steel. Some double shear joist hangers are available in ZMAX coating.
View Details
$9.09
2X8 JOIST HANGER ZMX
This hanger features patented double shear nailing, which distributes the load through 2 points on each joist nail for greater strength. It also allows for the use of fewer nails, faster installation, and the use of common nails for all connections. 18-gauge galvanized steel. Some double shear joist hangers are available in ZMAX coating.
View Details
$10.458
2X10 JOIST HANGER ZX
This hanger features patented double shear nailing, which distributes the load through 2 points on each joist nail for greater strength. It also allows for the use of fewer nails, faster installation, and the use of common nails for all connections. 18-gauge galvanized steel. Some double shear joist hangers are available in ZMAX coating.
View Details
$15.99
2X6 DBL JOIST HANGER ZMX
This hanger features patented double shear nailing, which distributes the load through 2 points on each joist nail for greater strength. It also allows for the use of fewer nails, faster installation, and the use of common nails for all connections. 18-gauge galvanized steel. Some double shear joist hangers are available in ZMAX coating.
View Details
$22.49
4X4 HALF BASE Z-MAX
The BC series offers dual-purpose post cap/base for light cap or base connections. Do not install bolts into pilot holes. Install with 16d common nails or 16d x 2-1/2" joist hanger nails. Post bases do not provide adequate resistance to prevent members from rotating about the base and are not recommended for non top-supported installations (such as fences or unbraced carports). 18-gauge galvanized steel. Some sizes available with ZMAX coating.
View Details
$3.49
FRAMING ANGLE Z-MAX
This anchor's exclusive bending slot allows instant, accurate field bends for all 2-way and 3-way ties. Balanced, completely reversible design permits the A35 series angle to secure a great variety of connections. Used to reinforce 90 deg. connections. 18-gauge galvanized steel. Also available with ZMAX coating.
View Details
$4.29
MUDSILL ANCHOR Z-MAX 15"
Mudsill foundation anchors provide an alternative to anchor bolts. They easily mount on forms and make finishing easier. The unique design provides installation flexibility, eliminating problems with misplaced anchor bolts. Suitable for stem wall or slab foundations, mudsill anchors are 1-piece so there are no more nuts and washers to lose. Sill size: 2x4 or 2x6; install sides with (2) 10d x 1-1/2" and top with (4) 10d x 1-1/2" fasteners. 18-gauge galvanized ZMAX coated steel.
View Details
$261.59
4.75GL N/FB ASP FNDTN CT
Excellent non-fibered coating for dampproofing exterior vertical, below-grade masonry walls. Dries to a tough, flexible, weather resistant film. Resists damage which may result from expansion and contraction caused by weather, temperature variation, and normal building vibration. Can be used on exterior surface of underground storage tanks and pipes, stone, brick, or concrete surfaces. Coverage is approximately 1.5 Gal. per 100 Sq. Ft. depending on texture and porosity of surface. Apply by brush or spray equipment. Do not apply if there is a threat of rain within 24 hours after application. Limited 12 month warranty.
View Details
$17.391
12OZ SD WNDW&DR SEALANT
Polyurethane foam sealant exclusively formulated to air-seal the gap between the window or door, and its rough opening. Low-pressure formula sprayed into rough opening expands to fill gap, and will not buckle or bow window or door frames. Smart Dispenser precisely fills voids and gaps, and is reusable up to 30 days. Soft pliable yellow foam is easy-to-remove if gap is overfilled. Complements energy efficiency of window or door by providing a permanent weather-tight air seal, reducing heating and cooling costs. Foam repels water and prevents wood rot and other weather related problems associated with moisture. One 12 oz. can will foam up to 4 average sized residential windows (36" x 60", 3/8" wide gap, 1" deep). Conforms to ASTM standards.
View Details
$42.99
4X4 POST CAP BASE Z-MAX
The BC series offers dual purpose post cap/base for light cap or base connections. Do not install bolts into pilot holes. Install with 16d common nails or 16d x 2-1/2" joist hanger nails. Post bases do not provide adequate resistance to prevent members from rotating about the base and are not recommended for non top-supported installations (such as fences or unbraced carports). 18-gauge galvanized steel. Some sizes available in ZMAX coating.
View Details
$5.29
2X1-1/2X2-3/4 ANGLE ZMAX
Used to reinforce right angle connections. Fastens wood to wood. This product is made to help resist lateral forces. Great for home repair projects. 90 deg. angle. Galvanized steel. Some sizes available with ZMAX coating.
View Details
$3.49
2X1-1/2X1-3/8 ANGLE ZMAX
Used to reinforce right angle connections. Fastens wood to wood. This product is made to help resist lateral forces. Great for home repair projects. 90 deg. angle. Galvanized steel. Some sizes available with ZMAX coating.
View Details
$6.99
H1Z HRCN TIE ZMAX
Provides resistance to uplift and lateral forces. Designed to help counter the effect of high wind and seismic events on a structure. Used also for general tie purposes, strongback attachments, and as an all-purpose tie where 1 member crosses another. Install in pairs to connect 2x rafter to top plate. Some sizes available with ZMAX coating.
View Details
$4.99
H2.5AZ HRCN TIE ZMAX
Provides resistance to uplift and lateral forces. Designed to help counter the effect of high wind and seismic events on a structure. Used also for general tie purposes, strongback attachments, and as an all-purpose tie where 1 member crosses another. Install in pairs to connect 2x rafter to top plate. Some sizes available with ZMAX coating.
View Details